350Z Valve Cover Torque Specs. #6 · apr 29, 2011. Torque depends on gasket material, for normal lycoming cork gaskets 50 inch pounds for silicone gaskets about 30 inch pounds.
#2 · jun 26, 2011. The nut on the rocker arms does not have a torque spec as they are used to set the lifter adjustment, on the hydraulic valve lifters. I use 6 ft lbs.
Table of Contents
Two Critical Torque Settings Are For The Installation Of The Intake Manifold (Magnesium) Bolts And The Valve Cover Bolts (Integrated Cam Bearings).
Took me a long time to clean it up most of it. So are they like car valve covers where its just tighten enough to not squeeze the gaskets out or some particular torque setting? The nut on the rocker arms does not have a torque spec as they are used to set the lifter adjustment, on the hydraulic valve lifters.
Bell Housing To Engine Block.
Center bolt valve covers get torqued down 106 inch pounds. Put some gasket dressing between the new gasket and the covers only. The trick though is to go to 3 ft lbs on each bolt, slowly.
I Have A Carbed 5.7 Vortec With Chrome Center Bolt Valve Covers.
Once you have confirmed 3 ft lbs, then slowly go to 6 ft lbs. So far no leak, but not holding my breath. These normally need to be replaced when oil is found in the spark plug recesses as the gaskets for those recesses are not replaceable.
Does Not Fit 07+ 350Zs Or 07+ G35 Sedans With The Vq35Hr Engine.
What are the torque specifications for the valve covers on a 1997 vortec 350? I've attached a picture below showing the proper torque sequence of the bolts. Torque is low 65 inch pounds.
Hey Guys, The Factory Spec For An '88 350 Tbi Valve Cover Is 10.2 Nm Or 90 Inch Lbs.
By the way, be sure (really sure) you clean the upper part of the valve cover before it gets removed. This results in a better seal between the valve cover and the head. Torque specs for glow plugs and valve cover bolts for.