How To Program Dish Remote To Tv. While at the device location, point your remote at the device. Depending on the device that you want to program,press and hold the tv,dvd,or aux button.
Press the up arrow on the remote, about one press every two seconds. The tv mode button will flash three times. Here is how to program a dish network remote control.
Table of Contents
How To Program Your Dish Remote To A Tv Or Another Device.
To accomplish this, first, use the mode button to open the door of the receiver. Press and hold the tv mode button on the upper part of your remote. Do the following to connect to tv 2 without your receiver.
With The Remote Pointing At The Desired Device, Press And Hold The Mode Button That You Want To Program Your Remote To Until All Of The Mode Buttons Light Up 2.
Control, Indicating It Has Paired With Your Dish Receiver Aux Input Sat Tv 4 Press The Sat Button On The Side Of The Remote Control 3 Open The Front Panel Of Your Dish Receiver, And Press The Sys Info Button Sys Info 2 Replace The Back Cover 54.0 Pull 1 Remove The Back Cover By Pushing.
At this point, the dish remote tv is ready to program. Press and hold the sat button on the dish remote control until all mode buttons (sat, tv, dvd, aux) illuminate. Press the receiver power button on the remote.
Press And Hold The Button On The Dish Remote That Corresponds To The Device You Want To Program (Tv, Dvd, Or Aux).
This is your pairing code. Be patient,because you may have to hold it for 10 or more seconds. Point your dish remote at the device you want to pair.
Press The Channel Up Button While Still Pointing At The Tv.
While at the device location, point your remote at the device. When they do, release the button and it will start blinking. After about 10 seconds, you should see all four mode buttons light up.